Keyence IV-M30 Instrukcja Użytkownika Strona 5

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 10
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 4
5
IV Series (Monitor) - IM_E
Unmounting from the wall mounting adapter
Unlock the monitor from the wall mounting adapter by pulling
toward the unlock button. And slide up to unmount the
monitor mounted to the adapter.
Unlock
Mounting to a panel
Operate the monitor by mounting it to a panel such as a
control board.
Mount the panel adapter (OP-87465) to the monitor, and
mount it to the panel.
1
Connect the power cable and monitor cable to the
monitor.
“Cables” (Page 6)
2
Mount the panel adapter to the monitor and x it
with the attached screws.
Screw : M3, 11 mm long, with 2 washers
Use the attached screws.
Tightening torque : 0.27 to 0.33 N·m
3
Mount the monitor with the panel adapter
mounted to the control board from the rear side,
and x it with the screws.
Make a “92mm x 111mm” size mounting hole on the
control board.
Mountable board thickness : 1 to 4 mm
Screw : M3, 7 mm long, with 4 washers
Use the attached screws.
Tightening torque : 0.5 N·m or lower
Strap holder
Stylus can be hung from the strap holder
using the hanging string (accessory).
Mounting to the DIN rail
Mount the DIN adapter (OP-87466) to the monitor, and
mount it to the DIN rail.
The monitor can be operated by the following methods.
Pick up the monitor from the DIN mounting adapter and
operate it.
Operate it while mounted on the DIN rail.
Mounting using DIN mounting adapter
1
Mount the monitor to the DIN mounting adapter.
Slide the monitor until the end of the stopper, and conrm
that the monitor is locked.
Stopper
Fixing to the DIN mounting adapter
To x the monitor to the DIN mounting adapter, use the
attached screws.
Screw : M3 x 2
Use the attached at head screw.
Tightening torque : 0.27 to 0.33N·m
Przeglądanie stron 4
1 2 3 4 5 6 7 8 9 10

Komentarze do niniejszej Instrukcji

Brak uwag