Keyence FS-N10 Series Instrukcja Użytkownika Pobierz pdf (Strona 20)

Installation and Connection

2-6

- Digital Fiber Sensor FS-N10 Series User's Manual -

2-2

Connecting the Fiber Unit

This section provides procedures for connecting the fiber unit and operating

precautions.

Install the fiber unit.

After the installation, check that the transmitter and receiver of the sensor are

spaced properly. Also check that the optical axis is aligned.

If the fiber unit is a free cut type, cut any excess length of the fiber.

(1) Insert the fiber into the hole in the cutter.

(2) Bring down the blade in a single, swift motion to cut the fiber.

Failure to observe the cautions below may result in an improperly

cut surface, which may reduce the detection distance.

· When cutting the fiber unit, be sure to use a gray fiber cutter

(OP-87098)

· Cut the fiber unit in a single motion without stopping the blade

halfway through.

· Do not use the same hole twice.

Open the dust cover in the

direction of arrow (1).

Move the fiber lock lever down in

the direction of arrow (2).

Fiber

(2)

(1)

Always insert fiber from the side with writing

Fiber cutter

(OP-87098)

Point

(1)

(2)

(3)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 115 116

Brak uwag

Keyence FS-N10 Series Instrukcja Użytkownika Strona 20